MID-2 Syllabus of Microprocessor and Microcontroller Interfacing(5TH SEM)

MID-2 SYLLABUS

SUBJECT CODE: 2150907 B.E. 5th SEMESTER

1	Review of logic devices and memories: Latches, Flip flops, Buffers,Controller buffer registers, Decoders Memory Cell, Internal organization of Memory Chips, Types of Memories Ram Rom PROM EPROM EEPROM, Flash Memory.
2	Microprocessor Based Systems: Digital Computer, Microprocessor, Microcomputer, Microcontroller, Van Neumann and Harvard Architecture, CISC and RISC Processors.
3	8085 Microprocessor: Architectural Block Diagram, Schematic and Pin diagrams, Pin functions, Bus Organization, Internal operations and registers, Externally initiated operations, Serial interrupt and I/O Control, Brief Introduction of Instruction and assembly language Program, (Complete 8085 instruction set and Programming of assembly language 8085 should not be covered & asked in the exam) Timing and Control Unit ,Microprocessor communication, Multiplexing of address/data bus, Generation of control signals, 8085 machine cycles,Fetch and execution of only MOV, STA, and OUT instructions with timing diagram.
4	8051 Microcontroller architecture: Introduction to MCS -51 Family microcontrollers, Architectural block Diagram, Pin diagram and Pin , Functions General Purpose and Special Function Registers, , Oscillator and clock circuit, Reset circuit, I/O Port circuits, Memory organization, Internal program and data memory.
5	8051 Assembly language programming: Programming model of 8051, Addressing modes, data transfer instructions, I/O Port programming, Arithmetic and Logical instructions, Bit level instructions, Branching instructions (Jump and loop Jump and call), writing programs (like time delay using loop. Concept of stack,  subroutine and related instructions
6	8051 Programming in C:Data types in 8051 C, programming for time delay(without timer module), I/O programming in 8051 C, Logic operations in 8051 C, Control statements and loops in embedded C, Functions and Arrays in embedded C.